• Menjelaskan tahapan start-up, commissioning, dan testing sesuai standar IEC, IEEE, NFPA (minimal 80% pemahaman dari pre-post test).

• Menyusun Commissioning Plan & Checklist lengkap untuk peralatan listrik (≥1 dokumen commissioning plan).

• Melakukan inspeksi, verifikasi, dan fungsi uji pada berbagai equipment (MV/LV switchgear, transformer, UPS, motor, proteksi relays).

• Melaksanakan pengujian electrical seperti insulation resistance, relay testing, hipot test, loop impedance test dengan benar (simulasi minimal 3 jenis tes).

• Menganalisis hasil pengujian dan mengidentifikasi potensi fault atau abnormal condition pada sistem kelistrikan.

• Melakukan troubleshooting awal berdasarkan hasil pengujian dan pola kegagalan umum (minimal 3 skenario simulatif).

• Menyiapkan final acceptance report dan handover documentation sesuai standar proyek.

• Menerapkan aspek K3 listrik selama pelaksanaan commissioning.

1. Electrical Engineer / Technician

2. Commissioning & Start-Up Engineer

3. Maintenance Supervisor / Planner

4. Project Engineer / Construction Engineer

5. QA/QC Electrical

6. Engineer di sektor industri: Oil & Gas, Power Plant, Mining, Manufacturing, Utilities, EPC, Infrastruktur

7. Profesional yang terlibat langsung dalam instalasi, testing, dan commissioning sistem kelistrikan

MODULE 1 – Introduction to Start-up, Commissioning & Testing

• Definisi & perbedaan start-up, commissioning, energization, handover

• Peranan commissioning dalam life cycle peralatan listrik

• Struktur organisasi commissioning & responsibility matrix

• Overview standar internasional: IEC 60364, IEEE Guide, NFPA 70E

• Risk awareness pada pekerjaan commissioning

MODULE 2 – Commissioning Strategy & Planning

• Tahapan pre-commissioning – commissioning – start-up – SAT/FAT

• Menyusun Commissioning Plan & Procedures

• Development of Inspection Test Plan (ITP)

• Menentukan acceptance criteria

• Interface management antara electrical, mechanical, dan instrument

MODULE 3 – Electrical Safety for Commissioning Work

• Lock Out Tag Out (LOTO)

• Arc flash hazard & PPE selection

• Energized vs de-energized testing

• Permit to Work (PTW) untuk commissioning

MODULE 4 – Electrical Equipment Pre-Commissioning

• Pemeriksaan dokumen: as-built, wiring diagram, datasheet

• Visual & mechanical checks

• Verification of cable installation

• Continuity & insulation resistance test (IR Test)

• Torqueing & connection checking

MODULE 5 – Power Distribution Equipment Testing

• LV & MV Switchgear pre-energization test

• Transformer tests (TTR, winding resistance, insulation, oil test overview)

• Busbar & earthing system testing

• Power Quality basic measurement

MODULE 6 – Protection Systems & Relay Testing

• Jenis-jenis relay (electromechanical, digital, numerical)

• CT & VT testing

• Primary vs secondary injection test

• Setting, coordination & verification

MODULE 7 – Motor, Generator & MCC System Commissioning

• Motor solo run & no-load test

• MCC (Motor Control Center) verification

• VSD/Soft starter commissioning

• Generator testing overview

MODULE 8 – UPS, Battery System & Auxiliary Equipment

• UPS functional testing

• Battery discharge test

• Charging system & alarms

MODULE 9 – Testing & Energization Sequence

• Standard energization procedure

• Synchronization of equipment

• Monitoring critical parameters during start-up

• Emergency response & abnormal scenario

MODULE 10 – Troubleshooting & Failure Analysis

• Common problems during commissioning

• Root cause analysis (RCA)

• Fault simulation & corrective action