• Menjelaskan dasar engineering pada heavy lifting & heavy transportation

• Mengidentifikasi crane, lifting equipment, dan heavy transport equipment yang sesuai untuk berbagai operasi onshore/offshore.

• Menyusun lifting plan dan transport plan

• Melakukan perhitungan dasar engineering: CoG, load distribution, sling tension, allowable deck load, stability check.

• Mengidentifikasi dan mengendalikan risiko operasi lifting & transport

• Menerapkan prosedur keselamatan dan komunikasi kritis selama operasi lifting dan loadout.

• Menyelesaikan analisis kasus gangguan (troubleshooting) dalam operasi lifting berat.

• Mempresentasikan rencana heavy lifting

1. Lifting Engineer / Rigging Engineer

2. Construction Engineer & Supervisor

3. HSE Engineer khusus area lifting operation

4. Marine Engineer / Naval Architect

5. Project Engineer (EPC, konstruksi, migas, industri berat)

6. Logistic & Transport Specialist

7. Crane Operator (level senior)

8. SPMT Operator / Heavy Haul Specialist

9. QA/QC Engineer terkait lifting & transport

MODULE 1 – Introduction to Heavy Lifting & Transportation

• Definisi heavy lifting & heavy haulage

• Onshore vs offshore lifting challenges

• Overview heavy-lift marine operations

• Kategori equipment dan aplikasi industri

MODULE 2 – Standards, Codes & Governing Regulations

• ASME B30 series

• DNV-ST-N001, DNV-ST-0378

• LOLER, OSHA

• Project-specific and client-specific requirements

MODULE 3 – Lifting Engineering Fundamentals

• Center of Gravity (CoG) calculation

• Load distribution

• Sling angle effects & tension calculation

• Shackle, sling, spreader bar, lifting beam selection

• Dynamic loading (marine operation)

MODULE 4 – Crane Types & Selection

• Crawler crane, tower crane, mobile crane

• Floating crane & sheerleg crane

• Crane load charts & derating factors

• Offshore lifts: heave, wind, vessel motion

MODULE 5 – Rigging & Lifting Accessories

• Inspection & certification

• Lift points design & padeye calculation overview

• Lifting lugs, hooks, wire rope, chain sling

MODULE 6 – Heavy Transportation (Onshore)

• SPMT (Self-Propelled Modular Transporter)

• Multi-axle trailer

• Route survey & load spread analysis

• Ground bearing pressure calculation

• Bridge crossing considerations

MODULE 7 – Marine Transportation & Loadout

• Barge selection & ballasting

• Loadout by SPMT / skidding system

• Sea fastening design basics

• Stability criteria for marine transport

MODULE 8 – Offshore Heavy Lifting

• Offshore lift phases (hook-up, splash zone, wave effect)

• Dynamic amplification factor

• Heave & wind loads

• Anchor & mooring requirement

MODULE 9 – Lifting & Transportation Planning

• Lifting plan & method statement

• Critical lift analysis

• Transport plan preparation

• Interface management dengan kontraktor lain

MODULE 10 – Safety, Risk & Communication

• HIRA & JSA untuk heavy lifting

• Exclusion zone & barricading

• Critical communication protocol

• Emergency response